Asbestos is a naturally occurring fibrous mineral used in many construction products. It is considered to be a carcinogen. Asbestos has been used in: sealant, putty, and spackling compounds; vinyl floor tiles, backing for vinyl sheet flooring, and flooring adhesives; ceiling tiles; textured paint; exterior wall and ceiling insulation; roofing shingles; cement board for many uses, including siding; door gaskets for furnaces and wood-burning stoves; concrete piping; paper, millboard and cement board sheets used to protect walls and floors around wood-burning stoves; fabric connectors between pieces of metal ductwork; hot water and steam piping insulation, blanket covering and tape; and as insulation on boilers, oil-fired furnaces, and coal-fired furnaces. The use of asbestos was phased out in 1978, but many older houses contain asbestos-bearing products.
Products containing asbestos are not always a health hazard. The potential health risk occurs when these products become worn or deteriorate in a way that releases asbestos fibers into the air. Of particular concern are those asbestos-containing products that are soft, that were sprayed or troweled on, or that have become crumbly. In this condition, asbestos is considered to be in a friable state.
The U.S. Environmental Protection Agency believes that as long as the asbestos-bearing product is intact, is not likely to be disturbed, and is in an area where repairs or rehabilitation will not occur, it is best to leave the product in place. If it is deteriorated, it may be enclosed, coated or sealed up (encapsulated) in place, depending upon the degree of deterioration. Otherwise, it should be removed by a certified professional.
A certified environmental professional could perform an inspection and make the decision whether to enclose, coat, encapsulate or remove deteriorated asbestos-containing products. Testing by a qualified laboratory, as directed by the environmental professional, may be needed in order to make an informed decision. Encapsulation, removal and disposal of asbestos products must be done by a qualified asbestos-abatement contractor.
For more information, visit www.nachi.org/go/epaasbestos
If ingested, lead can lead to a variety of health problems, especially for children, including brain damage and other serious issues.
Lead-based paint may be a hazard when found on surfaces that children can chew or that get a lot of wear and tear, such as windows and window sills, doors and door frames, stairs, railings, banisters, porches and fences. Lead from paint chips that are visible and lead dust that is not always visible can both be serious hazards. Lead dust can form when lead-based paint is dry-scraped, dry-sanded, or heated. Dust also forms when painted surfaces bump or rub together, such as when windows open and close. Lead chips and dust can get on surfaces and objects that people touch. Settled lead dust can re-enter the air when people vacuum, sweep or walk through it.
In 1978, the U.S. Consumer Product Safety Commission (CPSC) set the legal limit of lead in most types of paint to a trace amount. As a result, homes built after 1978 should be nearly free of lead-based paint. In 1996, the U.S. Congress passed the final phase of the Residential Lead-Based Paint Hazard Reduction Act, Title X, which mandates that real estate agents, sellers and landlords disclose the known presence of lead-based paint in homes built prior to 1978.
Lead-based paint that is in good condition and out of the reach of children is usually not a hazard. Peeling, chipping, chalking or cracking lead-based paint is a hazard and needs immediate attention.
If the house is thought to contain lead-based paint, consider having a qualified professional check it for lead hazards. This is done by means of a paint inspection that will identify the lead content of every painted surface and a risk assessment that will determine whether there are any sources of serious lead exposure (such as peeling paint and lead dust). The risk assessment will also identify actions to take to address these hazards.
The U.S. federal government has standards for inspectors and risk assessors. Some states may also have standards in place. Call your local housing authority for help with locating a qualified professional. Do-it-yourself home tests should not be the only method you use before embarking on a rehabilitation project or to ensure your family’s safety.
For more information on lead-based paint, consult the HUD Office of Lead Hazard Control website at www.nachi.org/go/epalead